DIRECT GAS FIRED HEATING
ideal for indoor swimming pools.

• Over 90% fuel efficient
• Reduces CO2 pollution
• Environmentally friendly
• No Sulphur Oxides (SOX)
• Very economical to run
• Up to 75% savings on energy costs
• Eliminates condensation
• Very low humidity
• Little or no ducting needed
• Units can be sited inside or outside the
  building or can fit on the roof
• Natural gas or L.P.G.
• Only 5 minutes to warm up

Our systems are designed on the pool area and the wetted pool surround. The unit provides a surplus of heated fresh air on a 'once through' basis. This slightly pressurises the building which means all the surface areas a 'swept' continually. Condensation cannot form and since the air change rate is around 8 changes per hour, humidity is controlled. the extract rate is designed to be slightly less than the supply rate to achieve the positive pressure.

Outside air passes into the unit and flows over a gas burner heating the air to around 40 deg C. There is not heat loss. The dilution rate to fresh air is approx 750 to 1 and complies with BS 5990 (Direct Gas Fired Appliances).

The positive pressure means that little or no ducting is needed (most domestic and hotel pools need no supply ducts). If air from the pool room leaks into adjoining areas through doors etc, it is 'good' air. The air change rate eliminates 'chlorine' or 'swimming pool' smells.

The system will heat up a pool room in just a few minutes. The standard of comfort for bathers and non-bathers alike is better than any other we know. The recommended air temperature when the pool is not covered is about the same as the water, but it is quite possible to run the air temperature lower than pool temperature.

The system has a 'set back' condition, for when the pool is not in use. Most pools have a heat retaining cover on during the set back period.

Domestic Pool, Aughton